Global Technology Systems Microwave Technology Used in Bulk Solids Flow_level_and Control Measuring.

GTS

Global Technology Systems

Solids flow measurement Onthelevel.com

Ramsey
Merrick
Katron
Endress Houser
Miltronics
Siemons
techweigh
SWR
solids
solid flow
measurement
measuring
​ dilutephase

dense phase

microwave technology

level switches

dust detection

mass flow

grains, rock, density, moisture, flow/no flow, point level, emissions,
belt scales, weigh feeders, loss in weight feeder, volume metric feeder,
Infrared Moisture detection, ProGap, ProGap 2, ProGap II, Jam detection,
Chutes, pipes, material blockage, microwave barrier, bulk material,
transmitter, receiver, containers, sensors, precipitators, inlet, outlet,
M-Sens 2, M-Sens II, online moisture meter, continuous moisture, dust, powders,
granulates, Ceramic, screw feeder, conveyor belts, bins, dryers, mixer,
aggregates, residual moisture, dryer tunnel, hot air zone, pneumatically
conveyed, Free fall condition, high speed particle counter, proportioning
system, totalizing, secondary fuel output, uniform distribution, Jam detection,
Chutes, pipes, material blockage, microwave barrier, bulk material, elevator,
air Chutes, rotary valve, sliding conditions, impact scales, velocity,
maintenance free, pulsating, ClampFlow, Hose lines, Dens-M, DensFlow, MaxxFlow
HTC, FlowJam, SolidFlow, ProGap S, Dusty, broken bag detection, triboelectric
technology, probe, SpeedFlow, ProSens, continuous velocity measurement, Dust
measurement, trend monitoring, downloads, manuals, brochures, software

 

 

(850) 651-3388

Dusty

Global Technology Systems ​ 

The Industry leader in SOLIDS Flow, Level and Moisture Measurement.

The Dusty is designed for filter bag leak detection. The Dusty is a compact unit consisting of sensor and control electronics built into an IP65 enclosure, which has been designed for easy installation and operation. 

Pre-adjusted alert level is 25 mg/m³ of organic dust material at 14 m/s air velocity. If the measure of dust is higher than this alert level the relay output will be switched. LEDs on the sensor show the status of measure, alarm output and internal function. Easy One Button User Interface allows you to; increase/decrease the alert level, perform an Auto Setup and restore factory settings

Optional PC software can change additional parameter (filter time, hold time, etc) of the sensor, to view signal trends and to write protocol files. The Dusty is designed for applications up to 2 bars and 110 °C. As an option the system can also be used in Ex-areas of category 3 (gas + dust).